|
The Twin
AP-Hydrojet dust suppression guns have been specifically
designed to provide immediate and efficient dampening/wetting of
large areas with minimal water application rate.
Immediately upon start-up, the stream break-up is activated. The
high frequency drive mechanism provides a fine water curtain and
gives excellent water distribution, thus avoiding erosion and
run-off.
The Komet dust suppression guns are easy to use, self-adjusting
and maintenance free. Rotation speed remains constant with all
pressures and nozzle combinations.
|
|
|
| |
Model |
Trajectory |
Nozzles
Ø |
 |
Hydrojet AP101 |
44º |
14 - 26 |
| Hydrojet AP101 VA |
46º - 28º |
14 - 26 |
|
<
Click for Performances > |
 |
Hydrojet AP140 |
44º |
18 - 32 |
| Hydrojet AP140 VA |
46º - 28º |
18 - 32 |
|
<
Click for Performances > |
|
All the above models
have Full or part circle operation and Flange connection |
Features
Angle of trajectory
The standard angle of trajectory is 44º
Variable trajectory angle
Where trajectory angles other than 44º are needed to suit specific
stock pile configurations, the variable trajectory angle device Vari-Angle
is recommended. It allows the trajectory angle to be
lowered. A lower water stream is affected less by wind and results
in a more efficient wetting of the area requiring dust suppression.
Construction and materials
This product has been specially engineered for reliability and high
performance in adverse environmental conditions. Twin Hydrojet
dust suppression guns are ruggedly constructed from carefully selected
materials. All moving parts are fully sealed. The specially
designed and patented lower bearing assembly features a built-in brake
system, which self-adjusts to the operating pressure.
The brake pads are constructed of an advanced hard wearing material for
maximum reliability. Lower bearing assembly does not include ball
bearings which can be subject to seizure due to water or sand
infiltration.
Corrosion protection
Prime materials combined with the protective coating each gun receives
after assembly, ensure good protection against a normal industrial
environment. A special hard anodized version of the raingun is
available as an option. All aluminium parts are individually hard
anodized prior to assembly. The hard anodizing of the gun,
combined with the additional coating ensures maximum protection against
adverse environments.
Rotation
The gun operates both part and full circle. The shift from part to
full circle operation is fast and simple. The rotation speed is
constant in both directions. This reduces vibrations and stress,
both on the gun and its support. An easy to operate speed selector
allows three speeds.
Maintenance
All moving parts are sealed and lubricated for the life time of the
raingun. No further maintenance is required.
|
|
For
further information please < contact us >
|